|
|
|
|
|
COIL SPRING COMPENSATOR
|
This is an exciting new product from the Seals-it product development group. It represents the culmination of two years of R&D activity aimed
at the need to develop a mechanism that will compensate for the rotation and alignment change that occurs every time a spring is compressed. The
new Coil Spring Compensator does both in a highly efficient and consistent manner.
Historically, suspension springs served their purpose and other than testing compression rates, tensions, recovery rates, etc., their function was taken for granted. In recent years, it has been
recognized that spring function has a great deal of influence over the racecars handling due to the rotation and alignment changes that occurs during
compression and rebound. As the spring is compressed, it has a natural need to “wind” that is restricted by the traditional “fixed” base the spring
sits on. This friction causes binding problems that also effect shock absorber performance.
The Seals-it Coil Spring Compensator rides on a cushion of ball bearings that rotate with the springs natural “winding”, virtually eliminating the
springs misalignment issues. This dramatically reduces the bending load that is absorbed by the shock absorber and allows the spring to function without restriction. The rubber sleeve that extends
above the base provides protection for the shocks threads and serves as a seal against dirt reaching the ball bearing assembly from the inside and an additional rubber seal prevents dirt from reaching the bearing
assembly from the outside.
|
|
For more information:
call our Tech Center toll-free at 866.584.8422 or
email us at techcenter@sealsit.com |
| Coil Spring Compensator |
| CSC2.5B |
SPRING COMPENSATOR, 2.5” I.D. SPRING, THREADED BODY SHOCK (2-1/8” DIA) |
$109.85 |
|
| SPECIFY THREADED BODY SHOCK OR SLEEVE AT TIME OF ORDER; SEPARATE BOOT FOR SLEEVE ALSO AVAILABLE SEPARATELY, SEE BELOW |
| CSAO75 |
ADAPTER FOR 5” DIAMETER SPRING |
$44.00 |
|
| SLIPS OVER CSC2.5B, HARD ANODIZED FINISH FOR LONG LIFE |
| CSC2.5BCOS |
2.5” SPRING, CENTER BOOT FOR COIL-OVER W/ 2.350” DIA. SLEEVE |
$15.21 |
|
| CENTER BOOT FOR 2-1/8” THREADED BODY ALSO AVAILABLE FOR SAME PRICE, SPECIFY W/ORDER |
| CSC2.5G |
SPRING LOCATOR TO GUIDE SPRING ON PERCH OPPOSITE COMPENSATOR |
$30.00 |
|
| REPLACES TIE WRAPS AND FLAT WIRE SPRINGS, EASY SLIP ON – FITS 2.5” SPRINGS |
| CSC2.5GTB |
SPRING LOCATOR, W/ NEEDLE ROLLER THRUST BEARING AND SEAL |
$66.00 |
|
| (REPLACES TIE WRAPS, FLAT WIRE SPRINGS, THE SEALED NEEDLE ROLLER THRUST BEARING AND PART NUMBER CSC2.5B MAKE THE ULTIMATE COMBINATION! – FITS 2.5” SPRINGS) |
| CSC2.5GTBT |
SAME AS CSC2.5GTB, WITH ADDITION OF INTEGRAL SPRING SEAT |
$76.25 |
|
| SHOCK TYPE MUST BE SPECIFIED AT TIME OF ORDER |
|
|
|
|